What is the 18ft wide x 32ft long Garden Pride Polytunnel
The 18ft wide Polytunnels allows for growers to expand their vegetable or fruit growing selection. Polythene is attached using our durable block ALUMINIUM profile rails, giving a tighter cladding to the structure. All the profiles including the inserts or clip in rails are made from hard-wearing aluminium. No plastic or wire inserts are used. Our Double Sliding Aluminium Doors allow for easy access. The cross bracing on the internal hoops allows for tall plants or shelves to be suspended.
What is included in the 18ft x 32ft Garden Pride Polytunnel Kit
-- 45mm High Tensile Z35 Steel Hoops (c/w EXTRA galvanisation)
Steel is up to 20 times more corrosion resistant than standard pre-galvanised tube
- Crop Supports for each internal hoop (includes STEEL supporting Down braces)
- Front Aluminium Gable end
- 1 x Set of Sliding Double Aluminium doors
- Rear Aluminium Gable end with large Net vent (which promotes air circulation around plants, but keep pests out!)
- Zip Up/Down Polyflap for rear net vent
- 1000G Clear Thermic Anti-Drip Polythene
- Block Aluminium Ground rail for sides and gable ends
- Anti Hot Spot Tape
- UV Repair tape included
- DIY - Building instructions included
VAT included
Dimensions:
Width: 18ft (5.5m)
Ridge Height: 10ft 5" (3.3m)
Internal Standing Height at sides: 6ft 6" (2m)
Straight Side Height: 3ft 9" (1.2m)
Steel Frame: All steelwork is high tensile Z35 Steel. All steelwork is galvanised to be 20 times more rust-resistant than pre-galvanised tubular steel.
- Hoops: 45mm Z35 High tensile steel
Gable ends:
- Uprights: Block Aluminium
- Lintel: Block Aluminium
- Double Door size for 18ft wide: 2.1m high x 1.94m wide
Ground Rails: How is polythene attached?
Aluminium Cladding system (Garden Pride range): Polythene is attached to the polytunnel structure by clipping in polythene with aluminium inserts to the block aluminum ground rail and uprights in gable ends. Need Building instructions?
Polythene Options:
Option 1: The standard polythene we use is a 1000G Thermic Anti-Drip Polythene. This is a clear film with the additional benefits of Thermic and Anti-drip properties.
'Thermic' - raises the temperature of the internal temperature by approx.1 to 2 Degrees celsius above the outside temperature.
'Anti-Drip' or 'Anti-Fog' - condensation evaporates or rolls off the polythene.
Option 2: Diffused Thermic 840G Polythene - This is a diffused film with the additional benefits of been Thermic.
'Thermic' - raises the temperature of the internal temperature by approx.1 to 2 Degrees celsius above the outside temperature.
'Diffused' - the sun's rays are 'dispersed' or 'diffused' to prevent plant scorching. The same amount of light is allowed in.
Polythene Warranty: A manufacturer's warranty against UVI degradation of the polythene is 5-6 years depending on the type of polythene picked. This warranty does not cover accidental damage, malicious damage, storm damage or general wear and tear etc.
Guidelines on how to care for your polythene
