For small narrow gardens check out the 10ft wide Garden Pride Polytunnel Range
The Garden Pride 10ft wide x 40ft polytunnel can be used in small narrow gardens or school yards. Polythene is attached using heavy duty block ALUMINIUM profile rails. All the profiles including the inserts or clip in rails are made from durable aluminium. Plastic and wire inserts are not used.
What is included in the Garden Pride Kit
- High Tensile Z35 Steel Hoops & Bracing
Steel is specially galvanised to be up more corrosion resistant than pre-galvanised tube
- Crop Supports with steel down braces (Both Cross- & Down braces are made from STEEL to give extra strength & support)
- Front Aluminium Gable end
- 1 x Sliding Aluminium door
- Rear Aluminium Gable end with large Net vent (promote air circulation around plants, reduces disease & keeps pests out!)
- Zip Up/Down Polyflap for rear Net vent
- 1000G Clear Thermic Anti-Drip Polythene
- Aluminium Ground rail for sides and gable ends
- Anti Hot Spot Tape for all hoops (not just ends!)
- UV Repair tape included
- NOTE: INSTALLATION OF STRUCTURE: Cost includes labour to install and also includes Quick setting cement for the foundation tubes of structure. If choosing for us to install, please note the site must be level and free from obstructions above and below ground. Please refer to our terms and conditions.
- VAT INCLUDED
Dimensions:
Width: 10ft (3.05m)
Ridge Height: 7ft 8" (2.35m)
Internal Standing Height at sides: 6ft (1.8m)
Straight Side Height: 3ft (1m)
Steel Frame: All steelwork is high tensile Z35 Steel. What is High tensile steel?
All steelwork is galvanised to be 20 times more rust-resistant than pre-galvanised tubular steel.
- Hoops: 35mm Z35 High tensile steel
- Bracing: 35mm Z35 High tensile steel
Gable ends:
- Uprights: Block Aluminium
- Lintel: Block Aluminium
- Door size for 10ft wide: 2.1m high x 0.97m wide
Ground Rails: How is polythene attached?
Aluminium Cladding system (Garden Pride range): Polythene is attached to the polytunnel structure by clipping in polythene with aluminium inserts to the block aluminum ground rail and uprights in gable ends. Need Building instructions?
Option 1: The standard polythene we use is a 1000G Thermic Anti-Drip Polythene. This is a clear film with the additional benefits of Thermic and Anti-drip properties.
'Thermic' - raises the temperature of the internal temperature by approx.1 to 2 Degrees celsius above the outside temperature.
'Anti-Drip' or 'Anti-Fog' - condensation evaporates or rolls off the polythene.
Option 2: Diffused Thermic 840G Polythene - This is a diffused film with the additional benefits of been Thermic.
'Thermic' - raises the temperature of the internal temperature by approx.1 to 2 Degrees celsius above the outside temperature.
'Diffused' - the sun's rays are 'dispersed' or 'diffused' to prevent plant scorching. The same amount of light is allowed in.
Polythene Warranty: A manufacturer's warranty against UVI degradation of the polythene is 5-6 years depending on the type of polythene picked. This warranty does not cover accidental damage, malicious damage, storm damage or general wear and tear etc.
Guidelines on how to care for your polythene
